by machinist:-) (Posted Sat, 04 Jun 2016 21:07:13 GMT)
greeting on the forum
im not sure if theres exist ""specific"" code for your control, but
generic Gcode will work for you
see among postprocessors, G-code, Gcode arc
according with grbl wiki site
you can set in header
G17 plane selection, usually this is the default..
G90
G91.1 this settings also default.. and artcam using incremental output
so possible it also set in default in your control..
in the footer you can set M30 if not set..
also check the website
https://github.com/grbl/grbl/wiki/Configuring-Grbl-v0.9
there are a couple of arduino and grbl forum.. with google you can find them...
Read Main Topic
greeting on the forum
im not sure if theres exist ""specific"" code for your control, but
generic Gcode will work for you
see among postprocessors, G-code, Gcode arc
according with grbl wiki site
you can set in header
G17 plane selection, usually this is the default..
G90
G91.1 this settings also default.. and artcam using incremental output
so possible it also set in default in your control..
in the footer you can set M30 if not set..
also check the website
https://github.com/grbl/grbl/wiki/Configuring-Grbl-v0.9
there are a couple of arduino and grbl forum.. with google you can find them...
Read Main Topic